INSTRUCTIONS FOR USE

1. Make sure surfaces are dry, clean and free from dust, dirt and grease. For even better bonding slightly roughen surfaces with sandpaper.
2. To take best advantage of the ultra-fast set, prepare the substrates carefully then check that you can hold them together for a couple of minutes until the adhesive is set.
3. Remove the cap from the center of the plunger so that the syringe may be sealed after use. Snap off the tab, to use.
4. Dispense equal volumes of resin and hardener onto a clean disposable surface. Mix well for 20 seconds, by stirring and folding with a plastic palette knife. It is important to ensure a thorough mix. Reseal syringe as soon as possible.
5. Apply the mixed adhesive to both surfaces of the joint and assemble carefully. A layer of adhesive 0.05 to 0.10 mm thick will normally impart the greatest lap shear strength to the joint.
6. Keep the joint supported until set. An approximate guide to support and handling times at room temperature is given below:
   Pot life: 90 seconds, approximately at 23^oC
   Support time: 4 minutes at 23^oC
   Full strength: 2 hours at 23^oC
   Setting times may be shorter in hot weather. In cold conditions the rate of curing of the mixed adhesive may be slowed down significantly and weak joints may result. For best results, use between 20^oC and 25^oC.
7. For a perfect finish carefully remove any excess adhesive with a sharp knife before the adhesive has fully hardened.

REMARKS

Thorough mixing is the key to getting a good cured product. Simply stirring leaves unmixed materials at the margins. Always fold in the edges then re-stir. Cured adhesive may yellow if exposed to sunlight for long periods.