Preparation

1. Surfaces must be dry and free from grease and dust.
2. Remove the required amount of adhesive from the can and mix with 2% catalyst on a clean surface for about 45 seconds, until a uniform mixture is formed. Do not mix adhesive in the can.
3. Mix the required amount each time since the mixture will harden within 10 minutes.

Bonding

1. Apply MARMOBOND on one surface only and assemble carefully, applying light pressure.
2. Keep the joint supported until fully set (approx. 1 hour).
3. Carefully remove any excess adhesive with a sharp knife before completely set.

Filling Äì repair

1. Apply MARMOBOND with a putty knife pushing material gently to fill the gap.
2. Finish surface with putty knife or spatula and remove any excess adhesive before completely cured.

It is advisable to perform a suitability test for each application.

REMARKS

• Do not apply MARMOBOND in very humid conditions or on hot or cold surfaces.
• Do not exceed the mixing ratio of 2% especially at high temperatures since this will accelerate curing.
• Place the caps correctly after use and close tight.
• MARMOBOND may be coloured using iron oxides. Make sure to mix iron oxides with adhesive Äì putty prior to the addition of the catalyst.